#Backup cisco switch config how to#
#Backup cisco switch config install#

You can watch the video below to save the settings of the Cisco Router and subscribe to our YouTubeВ channel to support us!

#Backup cisco switch config how to#

How to Copy Cisco Router SettingsВ в‡’ Video Username cisco privilege 15 password 0 cisco123 Now, when you check the configuration with the show running-config command to verify the backup and restore operation, you can see that the backup file has been successfully restored. In Destination filename, press Enter to verify that the file name you want to restore is running-config. To restore the RouterвЂ™s configuration, you must use the copy command again. You can check the existing configuration by opening the R1_Config file with notepad.ДЄfter you have completed the backup process, first make a few changes to the existing settings to restore the routerвЂ™s config file.ДЇor example, configure the FastEthernet0/1 interface and save the settings with the save command. You can also view the Log outputs on SolarWinds. When you check the server, you can see that the router configuration file is saved as R1_Config. In the following image, you can see that the configuration of the Router has been successfully backed up! R1#copy running-config tftp:ДЄddress or name of remote host ? 192.168.8.5Дestination filename ? R1_ConfigД©74 bytes copied in 4.444 secs (219 bytes/sec)

In the Remote Host section, do not forget to enter the IP address of the TFTP server! Now execute the following commands at the CLI command prompt to back up the running-config file on the router. Then start the service from the File menu.

#Backup cisco switch config install#

Ping the Windows 10 machine from the router CLI console to test the network connection.ДЄfter verifying the network connection, install and run the SolarWinds TFTP Server program on the Windows 10 VM. Ping the test from the VMware Windows 10 virtual machine to the RouterвЂ™s FastEthernet0/0 interface. In addition, create a new user and configure the Console connection to connect to your Router from a remote computer. Once you have completed the VMware Workstation settings, run GNS3 and create the topology as shown in the following illustration. Create a new virtual machineВ with VMware, and then configure the VMnet settings as shown in the image below.ДЄfter creating VMnet3, change the IP address to 192.168.8.2.ДЄfter completing the VMware Workstation settings, run GNS3 and create the topology as shown in the image below.